Toro Workman 3000 Series Service Manual page 115

11. Assemble reverse shaft:
A. Install gear (Item 2) onto reverse shaft.
B. Use a press to install bearings (Item 3 and 1).
12.Assemble main shaft:
A. Install gear (Item 18), gear (Item 17) and snap
ring (Item 16).
B. Install gear (Item 15).
C. Use a press to install bearing (Item 14).
D. Install washer (Item 13) and 2 needle bearings
(Item 12) onto main shaft. Apply moly disulfide
grease onto washer and needle bearings before
installing. Oil groove on washer must face the gear.
E. Install gear (Item 11) and snap ring (Item 10).
F. Install synchro ring (Item 6) onto gear (Item 11).
Apply Dexron III transmission oil on cone face of gear
before installing synchro ring.
G. Insert key (Item 9).
H. Install synchro hub sub–assembly (Item 8).
I. Install snap ring (Item 7).
J. Install synchro ring (Item 6) onto gear (Item 4).
Apply Dexron III transmission oil to cone face of gear
before installing synchro ring.
K. Insert 2 needle bearings (Item 5) into gear (Item
4). Apply moly disulfide grease onto needle bearings
before installing.
L. Install gear (Item 4) with synchro ring onto main
shaft.
M. Install washer (Item 3) and snap ring (Item 2). Ap -
ply moly disulfide grease to washer before installing.
Oil groove on washer must face the gear.
Workman 3000/4000 Series
6
4
5
3
2
1
10 6
7
Page 6 – 43
Figure 82
Figure 83
8
16
17
18
9
19
13
12
11
Figure 84
Drive Train
14
15