Assembly - Toro Workman 3000 Series Service Manual

Assembly (Fig. 115)
NOTE: Item numbers in figures are shown in reverse
order of assembly; for example, when reassembling,
install Item 1 last.
1. Clean gasket material from mating surfaces of hous-
ing and cover.
IMPORTANT: Be careful not to damage mating sur-
faces when removing gasket material.
2. Make sure all parts are free of dirt and dust.
3. Assemble shift arm:
A. Install two (2) new O–rings (Item 1) onto shift arm.
Apply moly disulfide grease to O–rings before instal -
ling.
B. Apply moly disulfide grease to arm pin and shaft.
C. Install shift arm into PTO housing.
D. Install shift lever onto shift arm.
E. Drive lock pins into shift lever and shift arm. Pay
attention to direction of slit in lock pins.
Workman 3000/4000 Series
3
Page 6 – 59
2
1
Figure 131
Figure 132
5
Figure 133
Drive Train