Engine Throttle Bracket - Toro Workman 3000 Series Service Manual

Engine Throttle Bracket

10
11
13
RIGHT
FRONT
1. Engine
2. Lock nut
3. Cap screw
4. Cap screw
5. Lock nut
6. Lock nut
Disassembly (Fig. 14)
1. Remove throttle bracket components from engine as
needed using Figure 14 as a guide.
Briggs/Daihatsu Diesel Engine
8
9
7
6
5
4
3
12
5
14
15
16
7. Ball joint
8. Jam nut
9. Threaded rod
10. Accelerator cable
11. Return spring
7
2
5
Figure 14
Assembly (Fig. 14)
1. Install removed throttle bracket components to en-
gine using Figure 14 as a guide.
2. Lubricate bellcrank grease fitting after assembly.
3. Check operation and adjustment of accelerator
cable (see Operator's Manual). If needed, adjust accel-
erator cable.
4. Check engine speed (both idle and high idle) and ad-
just if necessary (see Adjust Engine Speed in Adjust-
ments section of this chapter)
Page 4 – 20
1
12. Shoulder bolt
13. Grease fitting
14. Throttle bellcrank
15. Throttle bracket
16. Engine mount
Workman 3300–D/4300–D