Toro Workman 3000 Series Service Manual page 262

IMPORTANT: Make sure shims (14) are kept after
they are removed from the carrier assembly (15).
NOTE: Remove bearing cup (10) from the carrier hous-
ing (15) only if it needs replacing (see Inspection).
14.Pull bearing cup (10) and shims (14) from the carrier
assembly (15) (Fig. 24).
NOTE: Remove needle bearing (34) from the front
housing (2) only if it needs replacing (see Inspection).
15.Remove oil seal (33). Press needle bearing (34) from
the front housing (2) (Fig. 25).
Inspection (Fig. 11)
1. Inspect front housing (2) and carrier assembly (15)
for cracks and damage. Replace either part if its condi-
tion could affect the operation of the front differential as-
sembly. Clean flange surfaces of any sealant, oil, and
dirt (Fig. 26).
2. Inspect needle bearings (34) for wear and damage.
Replace bearings if needles are bent, do not rotate free-
ly, or do not remain in the bearing cage. Replace oil seal
(33) if it is cracked, nicked, torn, or distorted such that it
would not hold a proper seal (Fig. 27).
Front Wheel Drive (4WD) Page 10 – 20
Figure 24
Figure 25
Figure 26
Figure 27
Workman 4000 Series