Toro Workman 3000 Series Service Manual page 67

Fuel Tank Removal (Fig. 2)
1. Put vehicle on a level surface and engage parking
brake. Stop the engine and remove key from ignition
switch. Allow engine to cool.
2. Raise or remove the bed or other attachment(s). If
bed is raised, place safety support on lift cylinder (see
Operator's Manual).
IMPORTANT: Review safety information regarding
fuel handling in the Operator's Manual and Chapter
2 – Safety.
3. Disconnect negative battery cable first and then pos-
itive battery cable. Remove battery from vehicle (see
Operator's Manual).
4. Disconnect fuel line (item 13) from fuel filter on right
side frame rail. Drain fuel from the fuel tank into a suit-
able container.
NOTE: To prevent fuel leakage, do not loosen lower nut
on fuel sender stud.
5. Disconnect electrical wiring from the fuel sender on
the fuel tank.
6. Loosen socket head screws (item 21) and lock nuts
(item19) to allow tank straps to be unhooked from fuel
tank supports.
7. Remove fuel tank from vehicle.
Workman 3100
Fuel Tank Installation (Fig. 2)
1. Check felt straps (item 23) and replace if worn or
damaged.
IMPORTANT: Make sure that hydraulic lift cylinder
does not contact fuel tank.
2. Position fuel tank to tank straps and fuel tank sup-
ports. Hook tank straps to fuel tank supports. Tighten
socket head screws and lock nuts to secure fuel tank.
3. If fuel fitting was removed from tank, apply thread
sealant to threads of fitting before installing fitting into
tank.
4. Connect electrical wiring to the fuel sender.
A. Connect blue/white wire with ring terminal to the
center fuel sender terminal and secure with lock
washer and hex nut.
B. Connect black (ground) wire with the screw (item
6) that is closest to the frame rail.
C. Apply skin–over grease to the wire terminal con-
nections and cover center terminal with harness
boot.
5. Connect fuel line from tank outlet to fuel filter and se-
cure with clamp.
Connecting battery cables to the wrong battery
post could result in personal injury and/or dam-
age to the electrical system.
6. Position battery in vehicle (see Operator's Manual).
Connect positive battery cable first and then negative
battery cable.
7. Lower or install the bed or other attachment(s).
8. Fill fuel tank (see Operator's Manual). Check for fuel
leakage and correct if found.
Page 5 – 5
CAUTION
Kohler Gasoline Engine