Toro Workman 3000 Series Service Manual page 72

Engine Installation (Fig. 4)
1. Install flywheel (Item 33) and/or pilot bearing (Item
30) if removed. Torque socket head cap screw (Item 31)
from 35 to 41 ft–lb (47 to 56 N–m) to secure flywheel to
engine crankshaft.
2. If pressure plate and clutch disc were removed, see
Installing Clutch Disc and Cover in the Repairs section
of Chapter 6 Drive Train.
3. If hydraulic pump drive pulley was removed from en-
gine, apply antiseize lubricant on shaft surface before
installing pulley.
4. To install the engine, perform Engine Removal steps
in reverse order. Scrape RTV sealant off engine / bell
housing surface. Apply new sealant in same area during
engine installation.
Kohler Gasoline Engine
5. If shoulder bolt (Item 15) was removed, apply anti–
seize lubricant to bolt shoulder before installing.
6. Install a new engine oil filter. Fill engine with the cor-
rect oil (see Operator's Manual).
7. Install and adjust hydraulic pump drive belt (see Op-
erator's Manual).
8. Adjust accelerator and choke cables (see Operator's
Manual).
9. Lower or install bed or attachment(s).
Page 5 – 10
Workman 3100