Toro Workman 3000 Series Service Manual page 121

25.Install fork shaft case:
A. Insert spindle (Item 1) between fork shafts.
B. Insert 2 steel balls (Item 2) and 2 springs (Item 1)
into the grooves.
C. Apply silicone sealant to mating surface of fork
shaft case.
D. Install fork shaft case (Item 2). Tighten cap
screws (Item 1) to a torque from 18.5 to 22 ft–lb (24.5
to 29.5 N–m). Check operation of shifters and detent.
26.Insert a washer (Item 1) into housing of transaxle
case. Apply moly disulfide grease to washer before
installing.
Workman 3000/4000 Series Page 6 – 49
1
Figure 100
1
2
Figure 101
2
1
Figure 102
1
Figure 103
Drive Train