Toro Workman 3000 Series Service Manual page 132

4. Assemble PTO output shaft:
A. If bearing (Item 6) was removed, use a press to
install bearing onto output shaft.
B. Install washer (Item 5) and retaining ring (Item 4).
C. Install retaining ring (Item 3) and gear (Item 2).
D. Use a press to install bearing (Item 1).
5. Use a press to install bearing (Item 1) onto intermedi-
ate shaft.
6. Assemble PTO input shaft:
A. Insert spring (Item 3) and two (2) steel balls (Item
2) into hole.
B. Insert shift collar (Item 1) onto input shaft.
C. Move shift collar to "ON" position.
Drive Train
6
3
1
1
Page 6 – 60
5
2
Figure 134
Figure 135
Figure 136
2
Figure 137
Workman 3000/4000 Series
4
7
1
2
3