Emergency In Dmo - Motorola MTM800 Feature User Manual

If configured by your service provider, your MTM800 will
automatically attempt to get talk permit again and the
message will be displayed.
For Mic
During this pending time the MTM800 microphone is not active until
Emgcy Mic On
the
Receiving an Emergency Group Call
A terminal in TMO receives an Emergency Group Call to the
selected group or associated ATG (Announcement
Talkgroup), or scanned group. If the ATG is the currently
selected group, the terminal will receive the Emergency
Group Call to the group associated with this ATG. (For
information on the ATG, see page 30.)
When the MTM800 receives the call, the display will show
the caller's identity. If the display is idle, it will show
.
In Use
If upon entering Emergency mode your MTM800 receives an
emergency call, and Hot Microphone was enabled by your
Service Provider, the
Your MTM800 will attempt to get a talk permit.
In Emergency Hot Microphone Mode with powering on the
MTM800 by pressing the emergency foot switch (see "Powering
On/Off" on page 11): If a microphone/PTT set is connected to the
terminal front socket
installed the external microphone is opened.

Emergency in DMO

You can initiate an Emergency Group Call to a group.
You can receive a call from the selected talkgroup, and (if
configured by your Service Provider) from other users within
talkback range or from an open group. (An open group is a
super-group to which all DMO groups belong.)
Emergency calls can be placed via gateway and repeater.
For gateway and repeater settings, see "Gateway/Repeater
Selection" on page 42.
66
message is displayed again.
message will be displayed.
Wait For Mic
and
an external microphone/PTT set is
Wait
Emrgncy