Power Supply Wire Size; Selection Of Power Supply Wire Size (Example); Mr-J3 Series Power Supply Wire Size - Mitsubishi Electric MELSERVO-J3 Series Handbook

Part 8: Review on Replacement of Optional Peripheral Equipment

4. POWER SUPPLY WIRE SIZE

4.1 Selection of Power Supply Wire Size (Example)

4.1.1 MR-J3 series power supply wire size

POINT
Wires indicated in this section are separated wires. When using a cable for power
line (U/V//W) between the servo amplifier and servo motor, use a 600 V grade EP
rubber insulated chloroprene sheath cab-tire cable (2PNCT). For selection of
cables, refer to Servo Amplifier Instruction Manual.
To comply with the UL/C-UL (CSA) Standard, use the wires shown in the servo
amplifier for wiring. To comply with other standards, use a wire that is complied
with each standard.
Selection condition of wire size is as follows.
Construction condition: One wire is constructed in the air
Wire length: 30m or less
8 - 15