Mitsubishi Electric MELSERVO-J3 Series Handbook page 347

Part 6: Common Reference Material
Parameter
No.
Master-slave operation - Speed limit
PD32
adjusted value on slave
Note. For items that have no setting value listed in the table, refer to "Part 3: Review on Replacement of MR-J3-_B_ with MR-J4-_B_",
"Part 4: Review on Replacement of MR-J3W-_B_ with MR-J4W-_B_"..
(2) MR-J3W-_B => MR-J4W2-_B
Parameter
No.
PC01 Error excessive alarm level
PC03 Encoder output pulse selection
Note. For items that have no setting value listed in the table, refer to "Part 4: Review on Replacement of MR-J3W-_B with MR-J4W2-
_B".
(3) MR-J3W-0303BN6 => MR-J4W2-0303B6
Parameter
No.
PC05 Function selection C-2
Po04 Main circuit power supply selection
Note. For items that have no setting value listed in the table, refer to "Part 4: Review on Replacement of MR-J3W-_B with MR-J4W2-
_B".
Name Initial value
-
Name Initial value
-
-
Initial
Name
value
-
-
Setting
value
Master-slave operation - Speed limit adjusted value on
slave
Use MR-J4-_B_ with the software version A8 or later to
-
use this function.
A parameter error will occur when MR-J4-_B_ with the
software version A7 or earlier is used.
Setting
value
Although the initial values of the MR-J3-_B_ and MR-J3W-
_B are different, the same operation is performed.
-
Also, the setting ranges are different. Check the setting
values and change them as necessary.
Although the initial values of the MR-J3-_B_ and MR-J3W-
_B are different, the values are overwritten with the setting
-
values on the controller side (parameter of MR-J3-_B_)
after power-on.
Setting
value
Select a voltage to be connected to the main circuit power
supply with an MR-J4W2-0303B6 servo amplifier.
Main circuit power supply the characteristics of the servo
-
motor vary depending on whether 48 V DC or 24 V DC is
used.
[Pr. PC05]: "_ 0 _ _" DC 48 V (Initial value)
"_ 1 _ _" DC 24 V
The setting of this digit in the J3 compatibility mode is the
same as the MR-J3W-0303BN6 servo amplifier. Set it with
[Pr. Po04].
Main circuit power supply the characteristics of the servo
-
motor vary depending on whether 48 V DC or 24 V DC is
used.
[Pr. Po04]: "0 _ _ _" DC 48 V (Initial value)
"1 _ _ _" DC 24 V
6 - 70
Description
Description
Description