Supported Radius Attributes - ZyXEL Communications GS1920v2 Series User Manual

Table 197 Supported VSAs
FUNCTION
Ingress Bandwidth
Assignment
Egress Bandwidth
Assignment
Privilege Assignment
56.5.1.1 Tunnel Protocol Attribute
You can configure tunnel protocol attributes on the RADIUS server (refer to your RADIUS server
documentation) to assign a port on the Switch to a VLAN. The port VLAN settings are fixed and
untagged. This will also set the port's VID. The following table describes the values you need to
configure. Note that the bolded values in the table are fixed values as defined in RFC 3580.
Table 198 Supported Tunnel Protocol Attribute
FUNCTION
VLAN Assignment

56.5.2 Supported RADIUS Attributes

Remote Authentication Dial-In User Service (RADIUS) attributes are data used to define specific
authentication elements in a user profile, which is stored on the RADIUS server. This section lists the
RADIUS attributes supported by the Switch.
Refer to RFC 2865 for more information about RADIUS attributes used for authentication.
This section lists the attributes used by authentication functions on the Switch. In cases where the
Chapter 56 AAA
ATTRIBUTE
Vendor-Id = 890
Vendor-Type = 1
ingress rate (Kbps in decimal format)
Vendor-data =
Vendor-Id = 890
Vendor-Type = 2
egress rate (Kbps in decimal format)
Vendor-data =
Vendor-ID = 890
Vendor-Type = 3
Vendor-Data = "shell:priv-lvl=N"
or
(CISCO)
Vendor-ID = 9
(CISCO-AVPAIR)
Vendor-Type = 1
Vendor-Data = "shell:priv-lvl=N"
where is a privilege level (from 0 to 14).
N
Note: If you set the privilege level of a login account differently on the RADIUS
servers and the Switch, the user is assigned a privilege level from the
database (RADIUS or local) the Switch uses first for user authentication.
ATTRIBUTE
Tunnel-Type = VLAN(13)
Tunnel-Medium-Type = 802(6)
Tunnel-Private-Group-ID =
Note: You must also create a VLAN with the specified VID on the Switch.
Note: The bolded values in this table are fixed values as defined in RFC 3580.
GS1920v2 Series User's Guide
353
VLAN ID