Lan Static Dhcp Screen; Figure 59 Network > Lan > Dhcp Setup; Table 49 Network > Lan > Dhcp Setup - ZyXEL Communications P-2302HW-P1 Series User Manual

Figure 59 Network > LAN > DHCP Setup
Each field is described in the following table.
Table 49 Network > LAN > DHCP Setup
LABEL
DHCP Setup
Enable DHCP
Server
IP Pool Starting
Address
Pool Size
DNS Server
First DNS Server
Second DNS
Server
Third DNS Server
Apply
Cancel

7.2.3 LAN Static DHCP Screen

Note: This screen has no effect if the DHCP server is not enabled. You can enable it
in Network > LAN > DHCP Setup.
Chapter 7 LAN
DESCRIPTION
Select this if you want the ZyXEL Device to be the DHCP server on the LAN. As a
DHCP server, the ZyXEL Device assigns IP addresses to DHCP clients on the
LAN and provides the subnet mask and DNS server information.
Enter the IP address from which the ZyXEL Device begins allocating IP addresses,
if you have not specified an IP address for this computer in Network > LAN >
Static DHCP.
Enter the number of IP addresses to allocate. This number must be at least one
and is limited by a subnet mask of 255.255.255.0 (regardless of the subnet the
ZyXEL Device is in). For example, if the IP Pool Start Address is 10.10.10.10, the
ZyXEL Device can allocate up to 10.10.10.254, or 245 IP addresses.
Specify the IP addresses of a maximum of three DNS servers that the network can
use. The ZyXEL Device provides these IP addresses to DHCP clients. You can
specify these IP addresses two ways.
From ISP - provide the DNS servers provided by the ISP on the WAN port.
User Defined - enter a static IP address.
DNS Relay - this setting will relay DNS information from the DNS server obtained
by the ZyXEL Device.
None - no DNS service will be provided by the ZyXEL Device.
Click this to save your changes and to apply them to the ZyXEL Device.
Click this to set every field in this screen to its last-saved value.
P-2302HW/HWL-P1 Series User's Guide
123