Table 112 Access Control Logs; Table 113 Tcp Reset Logs - ZyXEL Communications P-2302HW-P1 Series User Manual

Table 111 System Maintenance Logs (continued)
LOG MESSAGE
Too large ICMP packet has
been dropped
Configuration Change: PC =
0x%x, Task ID = 0x%x

Table 112 Access Control Logs

LOG MESSAGE
Firewall default policy: [ TCP |
UDP | IGMP | ESP | GRE | OSPF ]
<Packet Direction>
Firewall rule [NOT] match:[ TCP
| UDP | IGMP | ESP | GRE | OSPF ]
<Packet Direction>, <rule:%d>
Triangle route packet forwarded:
[ TCP | UDP | IGMP | ESP | GRE |
OSPF ]
Packet without a NAT table entry
blocked: [ TCP | UDP | IGMP | ESP
| GRE | OSPF ]
Router sent blocked web site
message: TCP
Exceed maximum sessions per host
(%d).

Table 113 TCP Reset Logs

LOG MESSAGE
Under SYN flood attack,
sent TCP RST
Exceed TCP MAX
incomplete, sent TCP RST
Peer TCP state out of
order, sent TCP RST
Chapter 21 Logs
P-2302HW/HWL-P1 Series User's Guide
DESCRIPTION
The device dropped an ICMP packet that was too large.
The device is saving configuration changes.
DESCRIPTION
Attempted TCP/UDP/IGMP/ESP/GRE/OSPF access
matched the default policy and was blocked or forwarded
according to the default policy's setting.
Attempted TCP/UDP/IGMP/ESP/GRE/OSPF access
matched (or did not match) a configured firewall rule
(denoted by its number) and was blocked or forwarded
according to the rule.
The firewall allowed a triangle route session to pass
through.
The router blocked a packet that didn't have a
corresponding NAT table entry.
The router sent a message to notify a user that the router
blocked access to a web site that the user requested.
The device blocked a session because the host's
connections exceeded the maximum sessions per host.
DESCRIPTION
The router sent a TCP reset packet when a host was under a SYN
flood attack (the TCP incomplete count is per destination host.)
The router sent a TCP reset packet when the number of TCP
incomplete connections exceeded the user configured threshold.
(the TCP incomplete count is per destination host.)
The router sent a TCP reset packet when a TCP connection state
was out of order.Note: The firewall refers to RFC793 Figure 6 to
check the TCP state.
257