Wan Advanced Screen - ZyXEL Communications P-2302HW-P1 Series User Manual

P-2302HW/HWL-P1 Series User's Guide
Table 45 Network > WAN > Internet Connection (PPPoE)
LABEL
Get automatically
from ISP
Use Fixed IP
Address
My WAN IP
Address
Remote IP
Address
Remote IP Subnet
Mask
Metric
Private
WAN MAC
Address
Spoof WAN MAC
Address
Clone the
computer's MAC
address - IP
Address
Apply
Cancel

6.2.4 WAN Advanced Screen

Use this screen to set up DNS servers, RIP, and Windows Networking policies for the WAN.
To access this screen, click Network > WAN > Advanced.
112
DESCRIPTION
Select this if your ISP did not assign you a static IP address.
Select this if your ISP assigned you a static IP address.
Enter the IP address provided by your ISP.
Enter the IP address your ISP provided for the remote (peer) server.
Enter the subnet mask your ISP provided for the remote server.
Usually, you should keep the default value. This field is related to RIP. See
7 on page 117 for more information.
The metric represents the "cost of transmission". A router determines the best
route for transmission by choosing a path with the lowest "cost". The smaller the
metric, the lower the "cost". RIP uses hop count as the measurement of cost,
where 1 is for a directly-connected network. The metric must be 1-15; if you use a
value higher than 15, the routers assume the link is down.
Usually, you should keep the default value. This field is related to RIP. See
7 on page 117 for more information.
This field determines whether or not the ZyXEL Device includes the route to this
remote node in its RIP broadcasts. If you select Yes, this route is not included in
RIP broadcast. If you select No, the route to this remote node is propagated to
other hosts through RIP broadcasts.
Select this if you do not want to use the default MAC address for the ZyXEL
Device.
This field is enabled if you select Spoof WAN MAC Address.
Enter the IP address of the computer whose MAC address you want the ZyXEL
Device to use instead of the default MAC address.
Click this to save your changes and to apply them to the ZyXEL Device.
Click this to set every field in this screen to its last-saved value.
Chapter
Chapter
Chapter 6 WAN