Usa Type Supplementary Services; Table 64 Usa Type Flash Key Commands - ZyXEL Communications P-2302HW-P1 Series User Manual

P-2302HW/HWL-P1 Series User's Guide

10.1.3.3 USA Type Supplementary Services

This section describes how to use supplementary phone services with the USA Type Call
Service Mode. Commands for supplementary services are listed in the table below.
After pressing the flash key, if you do not issue the sub-command before the default sub-
command timeout (2 seconds) expires or issue an invalid sub-command, the current operation
will be aborted.

Table 64 USA Type Flash Key Commands

COMMAND
Flash
Flash
10.1.3.3.1 USA Call Hold
Call hold allows you to put a call (A) on hold by pressing the flash key.
If you have another call, press the flash key to switch back and forth between caller A and B
by putting either one on hold.
If you hang up the phone but a caller is still on hold, there will be a remind ring.
10.1.3.3.2 USA Call Waiting
This allows you to place a call on hold while you answer another incoming call on the same
telephone (directory) number.
If there is a second call to your telephone number, you will hear a call waiting tone.
Press the flash key to put the first call on hold and answer the second call.
10.1.3.3.3 USA Call Transfer
Do the following to transfer an incoming call (that you have answered) to another phone.
1 Press the flash key to put the caller on hold.
2 When you hear the dial tone, dial "*98#" followed by the number to which you want to
transfer the call. to operate the Intercom.
3 After you hear the ring signal or the second party answers it, hang up the phone.
10.1.3.3.4 USA Three-Way Conference
Use the following steps to make three-way conference calls.
158
SUB-COMMAND DESCRIPTION
Put a current call on hold to place a second call. After the second
call is successful, press the flash key again to have a three-way
conference call.
Put a current call on hold to answer an incoming call.
*98# Transfer the call to another phone.
Chapter 10 Phone