23.6.2 Incoming Calls
The following example shows the default behavior of your ZyXEL Device for incoming calls
when two SIP accounts are configured and you are using two phones. When a call comes in
from your SIP account 1, the phones connected to both phone port 1 and phone port 2 ring.
Similarly, when a call comes in from your SIP account 2, the phones connected to both phone
port 1 and phone port 2 ring. In either case you are not sure which SIP account the call is
coming from.
Figure 163 Incoming Calls: Default
In the next example, phone port 1 is configured to use SIP account 1 and phone port 2 is
configured to use SIP account 2 for incoming calls. In this case, every time you receive a call
from your SIP account 1, the phone connected to phone port 1 rings. Similarly, every time you
receive a call from your SIP account 2, the phone connected to phone port 2 rings. To apply
these configuration changes you need to configure the Analog Phone screen. See
on page
159.
Figure 164 Incoming Calls: Individual Configuration
Chapter 23 Troubleshooting
P-2302HW/HWL-P1 Series User's Guide
Section 10.2
281