Figure 112 Management > Static Route > Ip Static Route > Edit; Table 84 Management > Static Route > Ip Static Route > Edit - ZyXEL Communications P-2302HW-P1 Series User Manual

Figure 112 Management > Static Route > IP Static Route > Edit
Each field is described in the following table.
Table 84 Management > Static Route > IP Static Route > Edit
LABEL
Route Name
Active
Private
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Metric
Apply
Cancel
Chapter 16 Static Route
DESCRIPTION
Enter the name of the static route.
Select this if you want the static route to be used. Clear this if you do not want the
static route to be used.
Select this if you do not want the ZyXEL Device to tell other routers about this
static route. For example, you might select this if the static route is in your LAN.
Clear this if you want the ZyXEL Device to tell other routers about this static route.
Enter one of the destination IP addresses that this static route affects.
Enter the subnet mask that defines the range of destination IP addresses that this
static route affects. If this static route affects only one IP address, enter
255.255.255.255.
Enter the IP address of the gateway to which the ZyXEL Device should send
packets for the specified Destination. The gateway is a router or a switch on the
same network segment as the device's LAN or WAN port. The gateway helps
forward packets to their destinations.
Usually, you should keep the default value. This field is related to RIP. See
7 on page 117 for more information.
The metric represents the "cost of transmission". A router determines the best
route for transmission by choosing a path with the lowest "cost". The smaller the
metric, the lower the "cost". RIP uses hop count as the measurement of cost,
where 1 is for a directly-connected network. The metric must be 1-15; if you use a
value higher than 15, the routers assume the link is down.
Click this to save your changes and to apply them to the ZyXEL Device.
Click this to return to the previous screen without saving your changes.
P-2302HW/HWL-P1 Series User's Guide
Chapter
203