Table of Contents
Advertisement
»
If there is damage or wear:
–
Change the clutch facing discs and the clutch basket.
–
bl
Check needle bearing
»
If there is damage or wear:
–
Change the needle bearing and collar sleeve.
–
Check intermediate discs
»
If the intermediate discs are not flat or have punctiform outbreaks:
–
Change all intermediate discs.
–
Check clutch facing discs
»
If there is discoloration or scoring:
–
Change all clutch facing discs.
–
Check the thickness of clutch facing discs
Clutch facing disc - thickness
»
If the clutch facing disc does not meet specifications:
–
Change all clutch facing discs.
18.5.21 Preassembling shift shaft
bm
and collar sleeve
for damage and wear.
bn
for damage and wear.
bo
for discoloration and scoring.
bo
.
–
Secure the short end of the shift shaft in the bench vise.
Guideline
Use soft jaws.
–
Mount sliding plate
and put the guide pin on the shift quadrant.
–
Mount pressure spring
–
Slide on spring guide
set end facing upward, over the spring guide and lift the offset
312211-10
end over abutment bolt
–
Mount stop disk
≥ 1.9 mm (≥ 0.075 in)
1
with the guide pin facing downward
2
.
3
, push return spring
5
.
6
.
ENGINE 18
4
, with the off-
241
Advertisement
Table of Contents
