KTM 250 EXC TPI 2019 Repair Manual page 203

–
Position the clutch slave cylinder with the gasket.
–
Mount and tighten screws
Guideline
Screw, clutch slave
cylinder
R02865-11
–
Position the engine sprocket cover.
–
Mount and tighten screw
Guideline
Screw, clutch slave
cylinder
–
Mount and tighten screw
Guideline
Screw, engine
R02864-11
sprocket cover
–
Remove the locking piece and position the subframe.
Info
Watch out for the intake flange.
–
Position hose clip
R02862-11
–
Mount and tighten screw
Guideline
Screw, sub-
frame
–
Remove screw
–
Mount and tighten screw
Guideline
Screw, sub-
R02861-11
frame
–
Repeat these steps on the opposite side.
–
Tighten hose clip
–
Position the frame protector.
–
Mount and tighten screws
Guideline
Screw, frame protec-
tor
–
Mount the cable tie.
R02860-11
cl
.
M6 10 Nm (7.4 lbf ft)
cm
.
M6 10 Nm (7.4 lbf ft)
cn
.
M8 20 Nm (14.8 lbf ft)
co
but do not tighten yet.
cp
.
M8 35 Nm (25.8 lbf ft)
cq
.
cq
.
M8 35 Nm (25.8 lbf ft)
co
.
cr
with the washers.
M5 3 Nm (2.2 lbf ft)
ENGINE 18
Loctite ® 2701™
Loctite ® 2701™
201