Table of Contents
Advertisement
–
Move the brake fluid reservoir mounted on the handlebar to a
horizontal position.
–
Cover painted parts.
–
Remove screws
–
Take off cover
–
Extract the old brake fluid out of the brake fluid reservoir using
a syringe and fill with fresh brake fluid.
Syringe (50329050000) (
R02778-10
Brake fluid DOT 4 / DOT 5.1 (
–
Mount bleeder cover
Bleeder cover (00029013005) (
–
Connect the bleeding device.
Bleeding device (00029013100) (
R02779-10
–
Open shut-off valve
Info
Follow the instructions in the Owner's Manual of the
bleeding device.
–
Ensure that the filling pressure is set on pressure gauge
Correct the filling pressure on pressure regulator
sary.
201494-10
Guideline
Filling pressure
–
Pull off protection cap
Connect the bleeder bottle hose.
Bleeding device (00029013100) (
–
Open bleeder screw
Info
Drain until fresh brake fluid emerges in the bleeder bot-
tle hose without bubbles.
R02780-10
–
Tighten the bleeder screw.
–
Close shut-off valve
–
Open the bleeder screw again until brake fluid stops emerging.
Info
Overfilling of the brake fluid reservoir is prevented.
–
Tighten the bleeder screw. Remove the bleeder bottle hose.
Attach the protection cap.
–
Disconnect the bleeding device. Remove the bleeder cover.
1
.
2
with the membrane.
p. 364)
p. 358)
3
.
p. 362)
p. 362)
4
.
2 ... 2.5 bar (29 ... 36 psi)
5
of the brake caliper bleeder screw.
p. 362)
6
by approx. one half turn.
4
.
BRAKE SYSTEM 16
A
.
B
if neces-
173
Advertisement
Table of Contents
