KTM 250 EXC TPI 2019 Repair Manual page 291

–
Pour coolant in up to measurement
Guideline
10 mm (0.39 in)
Coolant
400243-10
–
Push protection cap
E00904-10
–
Unplug connector
–
Remove thermostat
escapes without bubbles.
–
Mount thermostat
Guideline
Screw, cylinder head
temperature sensor
–
Plug in connector
E00905-10
–
Position the protection cap
–
Pour coolant in up to measurement
Guideline
10 mm (0.39 in)
Coolant (
400243-10
–
Mount radiator cap
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use an effective exhaust extraction system when
starting or running the engine in an enclosed
E00906-10
space.
–
Allow the engine to warm up and cool down again.
WATER PUMP, COOLING SYSTEM 20
A
above the radiator fins.
1.2 l (1.3 qt.)
2
upward over the thermostat.
3
.
4
with O-ring and wait until the coolant
4
with the O-ring and tighten.
M10x1.25
3
.
2
.
A
above the radiator fins.
p. 358)
5
.
Coolant ( p. 358)
12 Nm (8.9 lbf ft)
289