Digital I/O Card-Adat (Cd8-At) - Yamaha O2R Owner's Manual

Digital I/O Card—ADAT (CD8-AT)
The ADAT digital I/O card (CD8-AT) is used to connect Alesis ADAT
compatible modular digital multitrack recorders to the 02R.
Installing the CD8-AT
The ADAT digital I/O card (CD8-AT) is a single slot card. For installation
instructions, see "Single Slot Cards" on page 221 of the User's Guide.
1. Connect the ADAT modular digital multitrack recorder to the 02R
using the appropriate connectors.
OUTPUT INPUT
OUTPUT
CD8-AT
SLOT 1
02R (Word clock slave)
75 Switch ON
Use the special ADAT optical cables to plug the IN connector of the
CD8-AT to the OPTICAL OUT connector of the ADAT modular digital
multitrack recorder. Plug the OUT connector of the CD8-AT to the
OPTICAL IN connector of the ADAT recorder.
If you have installed more than one CD8-AT in the 02R and have more
than one ADAT recorder, connect it in the same manner as the first unit.
The Alesis ADAT modular digital multitrack recorder does not have a
dedicated wordclock output connector. If you are using the BRC ADAT
remote controller, you can use the 48kHz OUT connector and an
appropriate cable to plug it into the WORD CLOCK—IN connector on
the back of the 02R and turn the 75 terminator switch on.
If there is no dedicated wordclock output, you can obtain the
wordclock signal required from the digital interconnect line.
Note: A dedicated wordclock line will give you the best wordclock
synchronization results.
Installing Options
INPUT
CD8-AT
OPTICAL
SLOT 2
OUTPUT
OPTICAL OPTICAL
OUTPUT INPUT
ALESIS ADAT
(Word clock slave)
227
OPTICAL
SYNC
INPUT
OUT
ALESIS ADAT
Word clock master
SYNC
IN
02R User's Guide