Options - Yamaha O2R Owner's Manual

Options

AD/DA I/O Card Specifications
Analog Input
Input
GAIN
connections
+4
INPUT 1
through 8
–10
*1 Sensitivity is the lowest level that will produce an output of +4 dB (1.23V) or the nominal output level when the unit
is set to maximum gain. (All faders and level controls are maximum position.)
*2 CH INPUT phone jacks are balanced. (Tip=HOT, Ring=COLD, Sleeve=GND)
In these specifications, when dB represents are specific voltage, 0 dB is referenced to 0.775 volts RMS.
In these specifications, when dBV represents are specific voltage, 0 dBV is referenced to 1 volts RMS.
Analog Output
Output connections
OUTPUT 1 through 8
*1 CH OUTPUT phone jacks are balanced. (Tip=HOT, Ring=COLD, Sleeve=GND)
In these specifications, when dB represents are specific voltage, 0 dB is referenced to 0.775 volts RMS.
In these specifications, when dBV represents are specific voltage, 0 dBV is referenced to 1 volts RMS.
Digital I/O Card Specifications
Digital Input/Output
Input/Output
DA88/DA38 (BUS/DIRECT OUT, TAPE IN) TDIF-1
ADAT (BUS/DIRECT OUT, TAPE IN)
AES/EBU (BUS/DIRECT OUT, TAPE IN)
YAMAHA (BUS/DIRECT OUT, TAPE IN)
CASCADE (BUS/DIRECT OUT, TAPE IN)
For use
Actual load
with nom-
impedance
inal
10k 600 lines
Actual source
GAIN
impedance
+4
150
–10
ADAT
AES/EBU
YAMAHA
YAMAHA
Input level
*1
Sensitivity Nominal
–6 dB +4 dB
(388mV) (1.23mV)
–20 dBV –10 dBV
(100mV) (316mV)
Output level
For use
with nom-
Nominal
inal
+4 dB
(1.23mV)
10k lines
–10 dBV
(316mV)
Format Level
C-MOS
OPTICAL
RS422
RS422
RS422
Specifications
Mixer
Max.
connector
before clip
+24 dB
(12.3mV)
Phone Jack
(TRS)
+10 dBV
(3.16V)
Mixer connector
Max be-
fore clip
+24 dB
(12.3mV)
Phone Jack
*1
(TRS)
+10 dBV
(3.16V)
Mixer connector
D-SUB 25PIN
XLR-3-31 type (INPUT)
XLR-3-32 type (OUTPUT)
D-SUB 25PIN
D-SUB 25PIN
D-SUB 25PIN
02R User's Guide
249
*2