Yamaha O2R Owner's Manual page 35

26 Introductory Recording Tutorial
02R Getting Started Guide
The gain increases in 0.5 dB steps and the EQ curve on the EQ page
changes to reflect this.
3. Rotate the encoder wheel counterclockwise to reduce the gain.
The gain decreases in 0.5 dB steps.
Alternatively, you could use the EQUALIZER G control.
4. Use the CURSOR buttons to select the gain (G) icon for the L-MID
band and adjust its level with the encoder wheel. Select the
other bands as well.
You can also select the EQ bands using the [LOW/HPF], [L-MID],
[H-MID], and [HIGH/LPF] buttons of the SELECTED
CHANNEL—EQUALIZER controls.
Note: Applying a lot of EQ boost may increase the signal level sufficiently to
cause distortion. If this does occur, reduce the amount of EQ boost or adjust the
attenuation level to compensate (the ATT icon). You can switch back to the
METER 1/3 page and select POST EQ to monitor the signal levels.
Note: You can reset the gain of each band to 0.0 dB by double-clicking the
corresponding [LOW/HPF], [L-MID], [H-MID], or [HIGH/LPF] buttons of the
SELECTED CHANNEL—EQUALIZER controls.