Using The Dynamics Library - Yamaha O2R Owner's Manual

Using the Dynamics Library

Once you have applied a dynamics processor to the stereo bus, you need to
know how to recall dynamics programs from the library and to adjust the
parameters to create your own dynamics programs.
Recalling Dynamics Programs
1. Use the [DYNAMICS] button to locate the DYNAMICS 2/2 page
shown below.
DYNAMICS
Alternatively, you could use the LIB icon on the DYNAMICS 1/2 page to
go to the DYNAMICS 2/2 page.
2. Use the CURSOR buttons to select the RECALL icon. Rotate the
encoder wheel to select a dynamics program.
The 02R will scroll through the available dynamics programs. The program
that is highlighted is the program that will be recalled when you press the
[ENTER] button.
3. Press the [ENTER] button.
The dynamics program is recalled.
If you attempt to recall a user program that is empty, the 02R displays an
error message, indicating that the selected memory location is not available
for recall.
Note: Unlike EQ and effects, it is sometimes necessary to apply a dynamics
processor to an input signal as you are recording multitrack sources. Some signals
are too unpredictable or noisy to record without some form of compression or
gating. However, you should be very selective about the dynamics you apply, as the
same rule holds: it is easy to add the effect, but very difficult to remove it
afterwards.
Secondary Recording Tutorial
02R Getting Started Guide
57