Yamaha O2R Owner's Manual page 162

52 MIXING Display Functions
02R User's Guide
This control duplicate Attenuation function. See "Phase and Attenuation"
on page 32 of the User's Guide.
Note: The attenuator rotary icon is adjusting the same parameter as in the
/ATT display function. When you boost the gain of the equalization curve,
you may cause the overall signal level to reach CLIP. Watch the level meters
for the selected pair as you adjust the EQ values. If CLIP is reached, digital
signal distortion will occur.
• EQ ON icon—Indicates the status of the EQ, on or off. The text "ON" is
highlighted when the EQ is on.
• Rotary icons—There is an icon for bandwidth (Q), center frequency
(F), and gain (G) for each of the four bands, LOW, L-MID, H-MID, and
HIGH.
Use the CURSOR buttons to select the desired icon and adjust its value
with the rotary encoder. Switch the EQ on or off by pressing the [ENTER]
button.
Equalization parameters:
Q
Peak 10 to 0.1
LOW/HPF in 41 steps /
SHELF / HPF
Peak 10 to 0.1
L-MID in 41 steps
Peak 10 to 0.1
H-MID in 41 steps
Peak 10 to 0.1
HIGH/LPF in 41 steps /
SHELF / LPF
*1 When the sampling frequency is 32 kHz, the frequency range (F) is 21 Hz to
15.1 kHz
F
21 Hz to 20.1 kHz 18 dB
in 1/12 octave in 0.5 dB steps
*1
steps HPF = ON/OFF
21 Hz to 20.1 kHz 18 dB
in 1/12 octave in 0.5 dB steps
*1
steps
21 Hz to 20.1 kHz 18 dB
in 1/12 octave in 0.5 dB steps
*1
steps
21 Hz to 20.1 kHz 18 dB in 0.5 dB
in 1/12 octave steps
*1
steps LPF = ON/OFF
G