Yamaha O2R Owner's Manual page 309

When you confirm a STORE or CLEAR operation, any existing data
in the selected program location will be overwritten or cleared.
YOU SHOULD ALWAYS BE CAREFUL WHEN THE 02R DISPLAYS
A CONFIRMATION DIALOG BOX!
• Recall Confirmation—With this option checked, the 02R will request
you confirm any scene memory or library recall operation.
• Remote Talkback (C3)—With this option checked, you can enable the
Talkback system by sending a MIDI Note On message for C3. You
disable the Talkback system by sending a MIDI Note Off message for
C3.
• Transmit Key Remote—With this option checked, when you operate
any buttons, controls, or faders, the 02R will transmit system exclusive
parameter change messages from its MIDI OUT connector. This is
intended to be used to remotely control another 02R.
• Insert Tx Bulk Wait—With this option checked, Bulk Dump data is
transmitted at intervals. When another device cannot receive 02R Bulk
Dump data correctly, turning this option on may help.
• Fast Meter Fall Time—With this option checked, the level meters will
respond more quickly to level changes. When the option is not
checked, the level meters delay their fall in order to allow you to see
the level changes more clearly.
• CR Level to MB02—With this option checked, the level of the C-R
MONITOR OUT signal is displayed on the optional MB02's stereo
meters.
• Pre Fader Direct Out—With this option checked, the direct output
signal is sourced pre fader. Normally, the direct output signal is
sourced post fader.
• Pre EQ Direct Out—With this option checked, the direct output signal
is sourced pre EQ. You cannot turn on both Pre EQ Direct Out and Pre
Fader Direct Out at the same time.
• Slate Tone—With this option checked, when you press the [SLATE]
button, a 50 Hz tone at –34 dB is recorded along with the talkback
input.
• TC Drop Warning OFF—With this option checked, the 02R will not
report a warning when the timecode reader detects a frame dropout.
If you have a noisy connection to your timecode source, or it was
poorly recorded on an analog recorder, this message may appear so
often that it becomes distracting. However, if you know your timecode
source is reliable, you may want to leave this option off so that the 02R
can warn you of any undesirable timecode events.
• DIO Warning OFF—With this option checked, the 02R will not report
a warning when an error is detected in the digital signals being input
from one of the digital I/O cards. When the 02R detects an error, the
message "DIGITAL I/O Error!" is flashed on the display.
If you have a poor connection to your modular digital multitrack
recorder or any other digital audio devices, this message may appear
so often that it becomes distracting. You should be aware that if the 02R
Digital I/O, Setup, and Utilities 199
02R User's Guide