Dynamics Display Function - Yamaha O2R Owner's Manual

1. Use the [DYNAMICS]
button to locate the
DYNAMICS 1/2 page.
DYNAMICS
2. Select a channel using
the [SEL] buttons.
Note: Press the [SEL]
button for the STEREO
channel to access the
dynamics processors for the
output buses.

DYNAMICS Display Function

Dynamics can be applied to the input channels (MIC/LINE 1 through 16,
LINE 17/18 through 23/24), the tape return channels (TAPE 1 through 16),
the internal bus outputs (BUS 1 through 8), and the stereo output. For
stereo and paired channels, the dynamics processor is applied equally to
both channels.
Shown below is the DYNAMICS 1/2 page.
The DYNAMICS 1/2 page shows the dynamics settings of the currently
selected channel.
The top of the page contains the dynamics LIB icon, the DYNAMICS icon,
the main control prompts (KEY IN, ST.LINK, and optionally IN), the
dynamics graph, and the gain reduction meter plus a level meter for the
currently selected channel pair.
The bottom of the page is split into two main sections:
The first section shows the channel KEY IN settings and LINK icons. These
settings can be changed using the CURSOR buttons, the encoder wheel,
and [ENTER] button.
The second section contains the controls for adjusting the parameters for
the currently selected channel. There are rotary icons for the threshold,
ratio, output gain, attack, release, and so on, depending on which dynamics
program you have selected. Use the CURSOR buttons to select the desired
icon and adjust its value with the encoder wheel. Press the [ENTER] button
to turn the dynamics processor on or off.
Dynamics 83
02R User's Guide