General Specifications; General Specifications - Yamaha O2R Owner's Manual

240 Specifications
Specifications
General Specifications
Number of scene memories
Sampling frequency
Signal delay
Fader resolution
Total harmonic distortion (THD)
Frequency response
Dynamic range
Hum & Noise (20 Hz to 20 kHz) *,
Rs = 150 , Input gain max.
Input pad = 0 dB
Input sensitivity = –60 dBV
Maximum Voltage Gain
Crosstalk(@1kHZ)
* Hum & Noise are measured with a 6 dB/octave filter @12.7 kHz; equivalent to a 20 kHz filter with an infinite dB/oc-
tave attenuation.
* Sampling Frequency: Internal 48 kHz
02R User's Guide
Specifications
96
Internal 44.1 kHz, 48 kHz
External (32 kHz –6%) to (48 kHz +6%)
Less than 2.5 ms. MIC/LINE input to STEREO output
+10 to –90, – dB (128 steps/100 mm) input faders.
0 to –120, – dB (128 steps/100 mm) stereo fader
Less then 0.2%, 20 Hz to 20 kHz (analog output) @+14 dB into 600
+1, –3 dB, 20 Hz to 20 kHz @+4 dB into 600
110 dB typical D/A Converter (STEREO OUT) *
105 dB typical A/D to D/A (MIC/LINE IN to STEREO OUT) *
–128 dB Equivalent input noise
–88 dB residual output noise. STEREO OUTPUT. STEREO OUT-
PUT off
–88 dB (92 dB S/N) STEREO OUTPUT. Master fader at nominal lev-
el and all channel faders at minimum level
–64 dB (68 dB S/N) STEREO OUTPUT. Master fader at nominal lev-
el and one input fader at nominal level
74 dB MIC/LINE (1 through 16) IN to STEREO OUT
74 dB MIC/LINE (1 through 16) IN to AUX SEND 1, 2, 3, 4, 5, 6 (via
PRE INPUT FADER)
74 dB MIC/LINE (1 through 16) IN to MONITOR OUT (via STEREO
bus)
54 dB LINE (17 through 24) IN to STEREO OUT
70 dB adjacent input channels
70 dB input to output