Memory Card - Yamaha QY100 Service Manual

QY100
MIDI Buffer Full
XG Data Error
XG Adrs Error
XG Size Error
Checksum Error
Host is OffLine

Memory Card

No Name
No Card
Card Mount Err
Too Many Files
Too Long Path
Not Empty
Card Write Err
Card Protected
Same Name Exists When using the Rename or Make Directory function you have entered
Read Only File
Card Full
40
This will appear when the MIDI reception buffer of the QY100 has
filled up, and processing was not possible. Try decreasing the amount
of data or increasing the interval time and transmit the data once again.
This appears when the received XG parameter change contains a data
size error
This appears when the received XG data contains an address error.
This appears when the received XG bulk data contains a data size error.
This appears when the received XG data contains a Checksum error.
If the QY100 is connected to a computer, this appears when the com-
puter's power is switched OFF. Switch the computer's power ON.
You have attempted to execute a save or load operation without speci-
fying afile or directory name.
This message will appear if you press the [CARD] button when no
memory card is in the QY100 CARD slot (or a card has not been prop-
erly inserted).
Make sure a memory card is properly inserted in the CARD slot before
pressing the [CARD] button.
An error occurred while accessing the memory card.
Re-insert the card and try again.
This message will appear if you attempt to store 100 or more files and/
or directories in a single directory.
The QY100 can display a maximum of 99 files and directories per direc-
tory.
The directory path (the string of characters that specifies the location
of a directory) is longer than 100 characters.
QY100 directory paths can be up to 99 characters in length.
You have attempted to delete a directory that contains one or more
files or other directories.
All files and directories contained in a directory must be deleted before
that directory can be deleted.
An error occurred while writing data to the memory card.
Re-insert the memory card and try again.
You have attempted to execute a store or other write operation to a
write-protected memory card.
Remove the write-protect seal from the card and try again.
a file or directory name that already exists.
Use a different file or directory name.
This message will appear if you attempt to write to or delete a read-
only file.
There is not enough memory available on the card to store the speci-
fied file.
Delete unwanted files from the memory card to make more memory
available, and then try again.