Dukane 5000 Series User Manual page 79

Linear vibration welder
Table of Contents

Advertisement

VALVES
In Figure 6-31 on the previous page Valve 1 is shown as an
active valve. The valve is programmed to extend at CYCLE
START, and it will retract AT START OF HOLD. Table 6-I
shows the selection possibilities for Extend and for Retract
CONFIGURABLE I/O
Valves and Valve Sensors Status
The tables below provide a key to the status symbols used
with the valves and valve sensors..
Valve
Status
Table 6-II
Each valve is paired with
extend and retract sensors.
Dukane Manual Part No. 403-589-01
Valve disabled
.(dark gray)
Valve enabled.
(light gray)
Valve extending
(green).
Valve retracting
(green).
Valve Status
NOTE
Extend
OFF - Disabled
AT CYCLE START
AT DOOR CLOSED
AT TABLE HOME
AT EJECT
AT START OF WELD
PART LOCATORS
(only on valve 1)
Table 6-I
Valve Extend, Retract Selections
Sensor disabled
(dark gray)
Sensor enabled
(light gray)
Valve
Status
Output ON
(yellow)
Sensor ON
(green)
Table 6-III
Valve Sensor Status
Section 6 - Touch Screen
Retract
AT START OF HOLD
AT END OF HOLD
AT TABLE HOME
AT DOOR OPEN
AT START OF WELD
Page 73

Advertisement

Table of Contents
loading

Table of Contents