Dukane 5000 Series User Manual page 72

Linear Vibration Welder 5000 Series
Table Options
The Table Options screen allows the operator to set these
parameters:
• Table up and down speeds (in
• Table position,
• Part clamp speed,
• Table lift pressure (force),
• Table cart position, and
• Tool change position.
Table Up Speed in Setup
Adjust the table Up speed (how quickly the table travels
up) - in only.
Setup Mode
Table Down Speed in Setup
Adjust the table Down speed (how quickly the table travels
down) - in e only.
Setup Mod
Part Clamp Speed
Controls the deceleration speed prior to engaging the
work piece. Deceleration occurs 50mm before your trigger
position or table slow down setting.
Table Lift Pressure
The pressure the table uses during Setup mode and In Cycle
when weld and hold forces are not used.
Table Cart Position
When the Move to Table Cart button is pressed, the table
travels to the programmed table cart position.
Tool Change Position
When the Move to Tool Change button is pressed, the table
travels to the programmed tool change position.
Page 66
User's Manual
),
Setup Mode
Figure 6-25 Setup Mode - Table Options
NOTE
Using a table cart is a quick and safe
way of installing and removing tooling
from the lift table.
Dukane Manual Part No. 403-589-01