Dukane 5000 Series User Manual page 63

Section 6 - Touch Screen
Alarm Limits (Run & Setup Mode)
Optional
– If latch On suspect part is enabled with the
password set, then the alarm limit screen will pop up
automatically when there is a process fault. A password
is required to gain access to the machine controls on the
HMI. All the process values on the screen are read only.
Programming the process limits is done in Setup Mode.
See Section 6 - Setup for more information
Figure 6-18 shows how the Alarm Limits pop-up window
appears on the Operate screen.
Figure 6-18 Run Mode - Alarm Limits Pop-up Window
Page 57
Dukane Manual Part No. 403-589-01