Figure 8-29 Install The Battery; Figure 8-30 Install The Battery Case Cover - NEC Univerge SV8100 System Hardware Manual

Hide thumbs Also See for Univerge SV8100:
Table of Contents

Advertisement

UNIVERGE SV8100/SV8300
System Hardware Manual
2.
Turn the battery pack so that the connector with the red and black wires
is near the jack inside the battery compartment. Match the connector's
wire colors to the polarity label in the battery compartment (the
connector notches fit into the grooves of the jack only one way). Push
the battery pack connector into the jack until it clicks into place.
3.
Make sure you have a good connection by gently pulling on the battery
wires. If the connection is secure, the battery jack will remain in place.
4.
Place the battery case cover back on the handset and slide it upwards
until it clicks into place.

Figure 8-29 Install the Battery

Figure 8-30 Install the Battery Case Cover

Issue 1.0
8 - 25

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Univerge sv8300

Table of Contents