Figure 4-20 Install Additional Chs2U Stand Kit (Ext) - NEC Univerge SV8100 System Hardware Manual

Issue 1.0
4 - 24
Figure 4-21 Install Additional CHS2U STAND KIT (EXT)
4. Using supplied screws, secure the CHS2U STAND KIT to the
floor (refer to Figure 4-21 Install Additional CHS2U STAND KIT
(EXT) on page 4-24).
To prevent possible damage to the 19" chassis due to
falling, NEC recommends screws be installed in the
stand mount brackets as soon as possible.
5. Connect the ground wire to all chassis. Refer to
19" Chassis Grounding on page 4-39
grounding the system.
6. Refer to 3.5 Installing the 19" Chassis on page 4-27
installation of the chassis or, Chapter 5 paragraph
Installing an Extension or Trunk Blade on page 6-4
installation of blades.
UNIVERGE SV8100/SV8300
Metal
Brackets
3.5.5 Install
for complete details on
to continue
2.2
for
Installing the SV8100 Chassis