NEC Univerge SV8100 System Hardware Manual page 321

UNIVERGE SV8100/SV8300
System Hardware Manual
2.6.2 Performing a Hot Start
The section describes how to load system software from flash
memory and customer data from RAM memory.
System software is loaded from flash memory and the
customer data is loaded from RAM memory.
1. Turn the system power off.
2. Once it has powered down, press the button again to power the
system back up. Wait approximately two minutes.
3. When the system has completed reloading the software, the
Status LED is flashing on the CD-CP00-US.
2.6.3 Resetting the System
This section describes the process of resetting a system that is
running. Observe the important information listed in below.
To reset the system:
2.6.3.1 Initial Programming
The system can be programmed using three methods:
To program using a multiline terminal, enter programming
mode:
1. Go to any working display telephone.
2. Do not lift the handset.
3. Press Speaker.
4.
5. Dial the system password + Transfer.
IMPORTANT CONSIDERATIONS
Programming using a multiline terminal
PC Programming
Web Programming
In a newly installed system, use extension (port 1).
.
# #
Password
Issue 1.0
6 - 9