NEC Univerge SV8100 System Hardware Manual page 402

Issue 1.0
6 - 90
5.6.2 Installation
To install the CD-PRTA:
1. Plug the CD-PRTA into any universal slot on the chassis.
2. Use Program 10-51-01 (PRI/T-1) to set the CD-PRTA blade to
either PRI or T-1.
3. Connect the cable from the NT1 Network Termination cable to
the CN2 connector on the CD-PRTA. (Refer to
PRI Layout for NT-1 Network on page 6-91
diagram.)
With normal operation, LED 1 flashes green.
The CSU connects to the network through
an 8-pin RJ-45/RJ48C connector. Use
either the RJ48C plug-to-RJ48C plug,
which ships with the CSU or an RJ-45/
48C plug-to RJ-45/48C plug straight
through or CAT5 cable to connect the T1
to the CSU. (Refer to
CD-PRTA RJ48C Connector Pin-outs on
page 6-93.)
With PRI Networking, a cross-over cable
must be used on the master system's T1/
PRI blade or CSU to the telco
demarcation. If the systems are networked
side by side and not through telco, then a
straight-through cable is used.
Installing the SV8100/SV8300 Blades
UNIVERGE SV8100/SV8300
Figure 6-29
for a cabling
Table 6-52