Figure 5-20 Stand Mount Spacing Guide (Chs1U-Us+Chs2U-Usx1 Chassis Installation) - NEC Univerge SV8100 System Hardware Manual

Issue 1.0
3.3
5 - 20
3. Connect the ground wire to all chassis. Refer to
19" Chassis Grounding on page 5-46
grounding the system.
4. Refer to
installation of the chassis or, Chapter 5 paragraph
Installing an Extension or Trunk Blade on page 6-4
installation of blades.
Stand Mounting the 19" Chassis
The SV8300 can be stand mounted. Controlling and Expansion chassis can
be stand mounted using the CHS STAND KIT (K), the CHS2U STAND KIT
(EXT) and the CHS2U JOINT BRACKET KIT.
3.3.1 CHS1U-US+CHS2U-USx1 Chassis Installation
1. Using the spacing guide shown below, mark two holes to be
drilled. Refer to
(CHS1U-US+CHS2U-USx1 Chassis Installation) on page 5-21
for required spacing before drilling.
3.5 Installing the 19" Chassis on page 5-34
Figure 5-20 Stand Mount Spacing Guide
It is suggested that plywood first be
installed on the floor where the chassis
will be positioned. This allows for
secure anchoring of the screws which
will be supporting the weight of the
chassis.
For Stand Mount, up to three
CCHS2U-US chassis can stand with a
CHS1U-US chassis.
UNIVERGE SV8100/SV8300
3.5.7 Install
for complete details on
to continue
2.2
for
Installing the SV8300 Chassis