UNIVERGE SV8100
System Hardware Manual
2.
Turn the battery pack so the connector with the red and black wires is
near the jack inside the battery compartment. Match the connector wire
colors to the polarity label in the battery compartment (the connector
notches fit in the grooves of the jack only one way). Push the battery
pack connector into the jack until it clicks into place.
3.
Make sure you have a good connection by gently pulling on the battery
wires. If the connection is secure, the battery jack remains in place.
4.
Place the battery case cover back on the handset and slide it upwards
until it clicks into place.
Figure 6-29 Install the Battery
Figure 6-30 Install the Battery Case Cover
Issue 2.0
6 - 25