Tools And Materials Needed; Install The Drive - NEC NVM-2000 Manual

Installing an Expansion Drive

Install the Drive

Introduction
This supplement provides instructions for installing an expansion (slave) drive in the NVM-2000

Tools and Materials Needed

Install the Drive
To install the expansion drive:
Note:
1. From the Main Menu , select Exit .
2. Type the system password and press <Enter> .
3. Select Shutdown Voice Mail System to shut down the Voice Mail.
4. At the prompt, Are you sure you want to SHUT DOWN the Voice Mail System (Y/N)? , enter
5. After the Voice Mail shuts down, turn off the system power and remove the power cord.
6. Remove the monitor cord and the keyboard cord from the NVM cabinet.
7. From the rear of the cabinet, remove the 5 hex-head screws that secure the cover to the cabinet.
Issue 1-0
All manuals and user guides at all-guides.com
ESD Wrist Strap (to be worn on wrist and attached to a grounded metal object at all times)
Phillips-head screw driver
Diagonal cutters
Monitor and keyboard connected to NVM
Expansion Hard Drive with two U brackets
Do not turn off the NVM without first shutting it down. If you do not shut
down first, you may corrupt the NVM database when you turn it off.
Instructions assume you are using the Full Screen Editor.
Y .
See Figure 1. (The back of your cabinet may appear differently from the one shown).
Figure 1
Installing an Expansion Drive
WARNING
Install the Drive
DT-SPswap1
1