Setting Parameters In The Parameterizing Mode - Siemens SIRIUS 3RW50 Manual

Parameter assignment
5.8 Setting parameterizing mode via key combination on the 3RW50 soft starter
5.8.2

Setting parameters in the parameterizing mode

Requirements
● Activated parameterizing mode (Page 101)
Procedure
1. Select the desired parameter using the MODE key.
You can recognize your selection by the color of the STATE / OVERLOAD LED.
2. Change the setting of the selected parameter using the RESET / TEST key.
You can recognize your selection by the color combination of the three LEDs RN, ER and
MT.
Setting the parameter "Control via digital input" (selection in Step 1):
102
LED
STATE / OVERLOAD
Off
Lights up green
Lights up red
"RN" LED "ER" LED
Off Off
Off Off
Off
Lights up red
Lights up Lights up red
green
No selection
Control via digital input
Output ON / RUN
Control via digital input
"MT" LED
Manual activation
Off
Permanent activation
Lights up
yellow
Activate on bus error (factory setting)
Lights up
yellow
No change on bus error
Lights up
yellow
Manual, 09/2019, A5E35628455002A/RS-AA/001
Set parameter
Set parameter value
SIRIUS 3RW50 soft starter