Rotating The Wheels - Toro Pro Sneak 360 Operator's Manual

1. Snap-ring pin
3. Pull the 2 pins out of the blade.
Note: The plow blades are heavy. Make sure that 1
person is holding the blade while the other person is
removing the pins.
4. Place the new blade into the plow blade assembly and
secure it with 2 pins and 2 snap-ring pins.
Removing and Installing the Skid Shoes
1. Raise the plow about 91.4 cm (36 inches) off the
ground.
2. Stop the engine and remove the key.
3. Remove the 4 bolts, 4 nuts, and 8 washers from the
skid shoes (Figure 10).
g021986
1. Nut
2. Washer
3. Skid shoes
Figure 9
2. Pin
1
2
3
4
5
Figure 10
4. Washer
5. Bolt
4. Install the new skid shoes and secure them with the
previously removed hardware (Figure 10).

Rotating the Wheels

You can install the wheels to provide a narrow or a wide
overall width of machine. Install the wheels with the deep
concave toward the machine for operation in tight areas or
the shallow concave toward the machine for wider stability.
Important: Only operate on level ground with the
narrow wheel configuration.
Tire Size
G025774
23 x 10.5 x 12
26 x 12 x 12
1. Park the machine on a level surface, lower any
attachments, and stop the engine.
2. Remove the rear wheels.
3. Remove the step extension from the machine (Figure
11).
4. Install the wheels on the opposite side of the machine
from which each was removed.
5. Remove the front wheels and install them on the
opposite side of the machine from which each was
removed.
Note: Be sure to keep the tread going in the same
direction (see Figure 12).
17
Ply Rating Pressure
kPa
4 138
8 207
Figure 11
psi
20
30
g022223