Table of Contents
Advertisement
1. MOUNTING
1.2
Control Unit
1.2.1
Installation considerations
The control unit is designed to be mounted on a tabletop. When selecting a mounting
location, keep in mind the following points:
• Locate the unit where shock and vibration are minimal.
• Leave sufficient space around the unit for maintenance and servicing.
• Locate the unit with consideration for cable length.
• Keep in mind the compass safe distances shown on page i.
Note: The ground terminal is attached to the bottom of the unit. Connect a ground wire
(IV-1.25 sq, local supply) to the terminal before installing the unit.
1.2.2
How to mount the control unit
There are two methods you can use to mount the control unit.
Method 1: Factory default
Cable is fed from the
side of the control unit.
Method 1: Factory default
1. Referring to the outline drawings at the back of this manual, drill four pilot holes
for the self-tapping screws.
2. Remove the four cosmetic caps from the control unit.
3. Secure the control unit to the mounting location with the supplied self-tapping
screws (φ4×20, four pieces).
Method 2: Modified cable entry
Cable is fed from the
rear of the control unit.
Control unit cable
2
Cosmetic caps
Advertisement
Table of Contents
