Waveform Parameters Area - Teledyne T3AWG3K Series Operator's Manual

Waveform Parameters Area

This section is composed by two tabs: the Carrier tab and the Secondary tab.
•
In the Carrier tab it is possible to define the Run Mode, of the Carrier Waveform and its
parameters as explained in the relative chapter.
•
In the Secondary tab it is possible to define the parameters that describe the Modulation,
Sweep and Burst. This tab changes title name and functionality depending on the selected Run
Mode. For example if the Run Mode is Sweep the Secondary tab will take the title name
"Sweep" and the tab page will show the Sweep parameters. The same will happen for
Modulation and Burst modes. In Continuous Run Mode the Secondary tab is not active.
You can touch the parameter area to open the Virtual numeric keypad, edit the parameter value and its
measure unit.
Below there is a description of the keypad items:
.
2
.
1
Operator's Manual Simple AFG Application
3
.
4.
7.
5.
6.
30