Waveform Parameters Area - Teledyne T3AWG3K Series Operator's Manual

Operator's Manual Simple AFG Application
If you use the Swipe Left or Right gesture over the Command Bar Area you can switch
between the Tab Section.

Waveform Parameters Area

This section is different in base of the tab selected:
•
In the Carrier tab it is possible to define the Run Mode, the Carrier Waveform and its
parameters as explained in the relative chapter.
•
If the Run Mode option selected is different from Continuous, will compare another tab right
side Carrier Tab, it is possible to define the parameters that describe the Modulation, Sweep
and Burst. This tab changes title name and functionality depending on the selected Run Mode.
For example, if the Run Mode is Sweep the Secondary tab will take the title name "Sweep" and
the tab page will show the Sweep parameters. The same will happen for Modulation and Burst
modes. In Continuous Run Mode the Secondary tab is not active.
30