Main Channels Horizontal Parameter - Teledyne T3AWG3K Series Operator's Manual

Operator's Manual Simple AFG Application
High Level [V]
It defines the maximum level of the waveform expressed in Volts
Low Level [V]
It defines the minimum level of the waveform expressed in Volts
These parameters are available for all function excepts the DC level that is identified only by the Offset
parameter.

Main Channels Horizontal parameter

The horizontal parameters control the frequency, the phase and the shape of the waveform. The set of
available parameters depends on the selected waveform.
Frequency [Hz] / Period [s]
This parameter defines the frequency or the period of the generated waveform. This parameter is
available for all the functions except DC Level and Noise.
In sweep run mode it is replaced by the Phase[deg] or Start Freq./Stop Freq.[Hz] parameters .
38