Minolta EP1080 Service Manual page 178

(7) Adjustment of the 1st/2nd Drawer Reference Position
Requirement
Important
•
If the Paper Tray of the Drawer needs to be moved for adjustment, make sure that it is moved
straight, not slantwise (as skewed feeding of paper could result).
• Ready a test chart (A3 or 11" × 17") as shown on the
left. Draw a line on the chart at a point 20 mm from
the right edge as shown.
• Dimension A on the copy should measure 20 ±2.0
mm.
1. Place the test chart face down on the Original Glass
and align its rear left corner with the
Original Width Scale on the left side of the platen.
Then, lower the Original Cover.
2. Using the 1st Drawer, make two full size copies.
(Use A3 or 11" × 17" paper.)
3. Using the second copy, compare the position of the
reference line on the copy with that on the test chart.
4. If the line does not meet the requirement, slide out the
1st Drawer, loosen the four screws shown on the left,
and move the Paper Tray as necessary to the front or
rear.
5. Using the same steps (1 through 4), adjust the
reference position of the 2nd Drawer.
NOTE
IIf dimension A on the copy is smaller than 18 mm,
move the Paper Tray to the rear. If it is more than 22
mm, move the Paper Tray to the front.
D-55
marker on the