Instructions For Handling The Pwbs; Handling Of The Pc Drum - Minolta EP1080 Service Manual

1-2. INSTRUCTIONS FOR HANDLING THE PWBs WITH MOS ICs
The following precautions must be observed when handling P.W. Boards with MOS (Metal
Oxide Semiconductor) ICs.
During Transportation/Storage:
•
During transportation or when in storage, new P.W. Boards must not be indiscriminately removed
from their protective conductive bags.
•
Do not store or place P.W. Boards in a location exposed to direct sunlight.
•
When it becomes absolutely necessary to remove a Board from its conductive bag or case, always
place it on its conductive mat in an area as free as possible from static electricity.
•
Do not touch the pins of the ICs with your bare hands.
During Replacement:
•
Before unplugging connectors from the P.W. Boards, make sure that the power cord has been
unplugged from the outlet.
•
When removing a Board from its conductive bag or conductive case, do not touch the pins of the
ICs or the printed pattern. Place it in position by holding only the edges of the Board.
•
Before plugging connectors into the Board, make sure that the power cord has been unplugged
from the power outlet.
During Inspection:
•
Avoid checking the IC directly with a multimeter; use connectors on the Board.
•
Never create a closed circuit across IC pins with a metal tool.
•
When it is absolutely necessary to touch the ICs and other electrical components on the Board, be
sure to ground your body.

1-3. HANDLING OF THE PC DRUM

During Transportation/Storage:
•
Use the specified carton whenever moving or storing the PC Drum.
•
The storage temperature is in the range between −20°C and +40°C.
•
In summer, avoid leaving the PC Drum in a car for a long time.
Handling:
•
Ensure that the correct PC Drum is used.
•
Whenever the PC Drum has been removed from the copier, store it in its Container or protect it
with a Drum Cloth.
•
The PC Drum exhibits greatest light fatigue after being exposed to strong light over an extended
period of time. Never, therefore, expose it to direct sunlight.
•
Use care not to contaminate the surface of the PC Drum with oilbase solvent, fingerprints, and
other foreign matter.
•
Do not scratch the surface of the PC Drum.
•
Do not apply chemicals to the surface of the PC Drum.
•
Do not attempt to wipe clean the surface of the PC Drum.
D-2