Avaya S8700 Manual page 16

Install and Administer IP Connectivity Hardware
3
Read and follow any directions inserted into the package by the factory.
Table 1: Required Hardware
Comcode/Code
108525528
848525887
700234032
– 700207111
– 700181118
1
The adapter has an amphenol connector on one side and an RJ45 connector on the other
for connecting to the network at 100 Mbps.
2
Only if installing in old carriers or cabinets with WP cables.
Install a TN799DP C-LAN
Have the following equipment on site:
•
An unoccupied port slot for the TN799DP.
•
A 10 or 100 BaseT Ethernet connection into your LAN for the TN799DP.
•
One or more valid, unused IP addresses on the network (one for each TN799DP C-LAN) that can
be assigned to the C-LAN circuit pack. You also need the subnet mask and default gateway.
•
An Ethernet adapter for each TN799DP.
•
A CAT5 (100 Mbps) cable with a DW8 connector on each end.
Install the cables
1
Determine into which port slots you are putting the TN799DP C-LAN circuit packs.
From the rear of the media gateway:
2
Connect the Ethernet adapter to the Amphenol connector corresponding to each TN799DP slot.
See Cable Connection for C-LAN
page 17.
3
Connect one end of each CAT5 cable to each Ethernet adapter.
4
Install a cable from the media gateway to the network through a hub or 110 (purple) wall field as
required.
16
Description
TN799DP Control LAN circuit pack
IP Media Processor adapter
Migration kit (PEC code 63275):
– Upper circuit pack slot label
– Twisted pair I/O cables
NOTE:
If installing the TN799DP into an old carrier or cabinet, you must replace the WP cables,
which connect the backplane to the rear connector panel, with Twisted Pair I/O cables to
handle the 100 Mbps speed. Refer to
on replacing the wires.
1
2
Replace the WP Cables
on page 17. For a pinout of TN799DP, see
Quantity
1 or more
1/C-LAN
1
10
on page 29 for information
TN799DP Pinout
Adding New Hardware--S8700
November 2003
on